Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Como Homeowners
A broken garage door spring shows up without warning. You press the button, hear a sharp bang from the ceiling of the garage, and the door stops moving or hangs crooked on one side. Springs carry the full weight of the door, and when one lets go, lifting the door by hand isn’t safe and forcing the opener just burns it out. That’s where we come in. Our technicians have up to 11 years of experience and service everything from a single torsion spring to a matched pair on a heavy Clopay door. Same-day garage door spring repair in Como is available for failures that can’t wait, and we answer 24/7 at (855) 514-8247 with fast dispatch from 7am to 7pm.
We handle spring repair as a dedicated service, not a side job tacked onto general handyman work. It’s one of the most dangerous repairs in the trade, and it’s also one of the most commonly botched. Getting it right the first time matters.
Key Takeaways
- Typical spring repair in Como runs $180 – $340 for one spring; a matched pair is usually replaced together at about twice that.
- Springs are under extreme tension and should only be handled by a trained technician.
- Same-day service is available for broken springs and doors stuck open or closed.
- Technicians are equipped for LiftMaster, Chamberlain, Genie, and Clopay systems, among others.
- For a complete look at everything we handle, see our garage door repair in Como.
What Our Garage Door Spring Repair Service Includes
Spring repair covers the entire spring system, not just the broken piece. Here’s what each part of the work involves.
Torsion Spring Replacement
A torsion spring is the coiled spring mounted on a metal shaft above the door, and it does the heavy lifting by twisting as the door moves. Most modern doors in Como rely on one or two of these, and when one snaps, the door becomes dangerously unbalanced. We measure the existing spring, match the wire gauge, inside diameter, and length to the weight of your door, and replace it with a properly rated spring so the opener isn’t overworked.
Extension Spring Replacement
Extension springs stretch along the horizontal tracks on older doors, and they store energy differently than torsion springs. They wear at the ends and can fail with a snap that sends hardware flying if there’s no containment. We replace extension springs in matched pairs and confirm the door’s balance afterward so both sides carry the load evenly.
Broken Spring Repair
A broken spring usually announces itself with a loud bang and a door that won’t lift or slams down. The door may also look crooked because one side is no longer supported. We diagnose which spring failed, check whether its partner is close to failing, and repair or replace so the door travels straight and stays put when you let go of it halfway up.
Spring Adjustment
Sometimes a spring hasn’t broken but has lost tension, which shows up as a door that feels heavy, opens slowly, or won’t stay open. Adjustment means resetting the tension on the winding system so the door balances correctly through its whole travel. We check the balance by hand and adjust the springs so the opener only has to guide the door, not fight it.
Safety Cable Installation
Safety cables run through the center of extension springs so that if a spring breaks, the pieces stay contained rather than flying across the garage. Many older doors were built without them. We install cables on extension spring systems that lack them, which is one of the simplest ways to make an older door safer for everyone who uses it.
Spring Inspection
A spring inspection looks for the early signs of failure: gaps in the coil, rust, uneven tension, and worn end fittings. It’s worth doing when a door starts making new noises or opens unevenly, before something breaks. We inspect the springs, cables, and drums together because they wear as a system, and we tell you plainly what needs attention now and what can wait.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
We work on your brand, and that matters when it comes to spring systems. A LiftMaster opener paired with a torsion setup behaves differently under load than a Chamberlain unit, and the spring you install has to match the door’s weight, not just its make. We service LiftMaster equipment and know where it wears out when a spring has been weak for a while, and we handle Chamberlain systems the same way, checking that the opener’s force settings and travel limits are correct after a spring change.
Genie and Clopay doors come through our shop regularly too. Clopay doors vary widely in weight depending on the panel construction, so we match the spring to the actual door rather than guessing from the model number, and Genie openers need their limits reset once a new spring is in place. With brand-specific knowledge, you don’t have to replace a system that’s otherwise fine just to get reliable service. Whether you have a LiftMaster, a Chamberlain, a Genie, a Clopay, or any other make, we can help.
Signs You Need Garage Door Spring Repair Right Now
Springs rarely fail without warning. Here are the signs worth acting on.
- A loud bang from the garage. A torsion spring breaking sounds like a gunshot or a car backfiring. If you heard it and the door no longer opens, stop using the opener and call us.
- The door feels impossibly heavy. A balanced door should lift with one hand. If you have to strain to raise it, the spring has lost tension or broken, and the opener is doing work it wasn’t built for.
- The door hangs crooked or opens partway. A door that lifts on one side but not the other usually means one spring failed while its partner is still under tension. Running the opener like this can bend the tracks.
- A visible gap in the coil. Look at the spring above the door. A clean gap in the winding means it has broken, even if the door still moves a little.
- New noises when the door moves. Squealing or grinding that wasn’t there before often points to a spring that’s slipping or a cable that’s loose.
If you’re seeing any of these, don’t try to fix the spring yourself. Torsion and extension springs store an enormous amount of energy, and an untrained hand on a winding bar can be seriously hurt. This is a job for a trained technician.
Our Garage Door Spring Repair Process – Step by Step
- 1
We diagnose the failure. We check the springs, cables, drums, and opener to confirm exactly what failed and whether anything else is under strain. A broken spring often takes a cable or a drum bearing with it.
- 2
We measure and match. We measure the existing spring’s wire gauge, inside diameter, and length so the replacement matches the weight of your door. A spring that’s close but not right will wear out fast.
- 3
We give you a written estimate. You get the price before we start. No surprises, no invoice that grew while you weren’t looking.
- 4
We do the repair safely. We release tension with the proper winding tools, replace the spring or springs, and reset the system so the door is balanced. Matched pairs are usually replaced together.
- 5
We test and confirm. We run the door through a full open and close, check the balance by hand, and reset the opener’s travel and force limits. You see the door work before we leave.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Como?
Garage door spring repair in Como typically runs $180 – $340 for one spring, depending on the spring type, the weight of your door, and whether the cables or drums need attention too. That’s an estimated range. A matched pair is usually replaced together, so a pair costs about twice that range. Here’s how the common scenarios break down.
| Service | Typical Estimated Range |
|---|---|
| Spring repair (one spring) | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
What affects the price: the type of spring (torsion vs. extension), whether one or both springs are being replaced, the door’s weight and size, and whether a snapped spring damaged a cable or a drum. A door that was run on a broken spring for a while often needs the opener checked too.
How to avoid overpaying: get a written estimate before any work starts, ask whether both springs are being replaced and why, and be wary of anyone who quotes a flat price over the phone without seeing the door. The written estimate sets the final price, so the number you agree to is the number you pay. The estimate itself is free. Call (855) 514-8247 for an exact quote.
Garage Door Spring Repair Near Como – Our Service Area
We serve homeowners across Como and the surrounding neighborhoods, including St. Anthony Park, Hamline-Midway, and Merriam Park. We also cover nearby communities like Roseville, Little Canada, and North End. For a dedicated look at that part of our area, see our garage door spring repair in Roseville. Same-day service is available for broken springs across these areas, and we answer 24/7. For spring work in the northern part of our service area, visit our garage door spring repair in North End page.
Serving Como, MN – Our Local Coverage Area
We serve Como and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Como
Garage door spring repair is the replacement or adjustment of the springs that counterbalance your door’s weight, most often a torsion spring mounted above the door or extension springs along the tracks. When a spring breaks or loses tension, the door becomes too heavy for the opener and unsafe to lift by hand. A trained technician replaces the spring with one matched to your door’s weight.
Most single-spring replacements are done in about an hour once the technician has the right spring on hand. A matched pair, or a job that also involves a cable or drum, takes a little longer. We give you a realistic time estimate when we quote the work, so you know what to expect. Call (855) 514-8247 for a free estimate.
Spring repair in Como typically runs $180 – $340 for one spring, and a matched pair is usually replaced together at about twice that. The exact price depends on the spring type, the door’s weight, and any related parts that need attention. The written estimate sets the final price. Call (855) 514-8247 for an exact quote, and estimates are free.
Yes. We service LiftMaster, Chamberlain, Genie, and Clopay systems, along with Amarr, Wayne Dalton, Craftsman, and Raynor. Brand knowledge matters because spring systems and opener settings differ by make, and we check that your opener’s travel and force limits are right after a spring change. Whether you have one of these brands or any other make, we can help.
Same-day service is available for broken springs across Como. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening. Call (855) 514-8247 for a free estimate.
We stand behind our work, and the details of coverage are explained in your written estimate before any work starts. We replace matched pairs together rather than one at a time, which is the more reliable way to do the job. Ask us about coverage when you call, and we’ll be plain with you.
Clear the area under and around the door so the technician can work safely, and keep the door closed until we arrive. If the door is stuck open, keep kids and pets away from it. Don’t try to raise or lower it by hand. That’s it. Call (855) 514-8247 to get on the schedule.
Schedule Your Garage Door Spring Repair Service in Como Today
A broken spring doesn’t fix itself, and a door that’s been run on one is usually doing damage to the opener and tracks. Call (855) 514-8247 for a free estimate on spring repair in Como. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. You get a written price before we start, no-obligation, and a door that’s back on track. One call covers it all: springs, opener, and installation.
Written by the team at Garage Door Repair Como.